Iscsi Virtual-Target Name - Cisco MDS 9000 series Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

iscsi virtual-target name

To create a static iSCSI virtual target, use the iscsi virtual-target command. To revert to the default
values, use the no form of the command.
Syntax Description name
advertise interface
gigabitethernet slot/port
[.subinterface]
port-channel channel-id
[.subinterface]
all-initiator-permit
initiator
initiator-name
ip-address ip-address
ip-subnet
permit
pwwn pwwn-id
secondary-pwwn pwwn-id
fc-lun number
iscsi-lun number
sec-lun number
trespass
OL-8413-07, Cisco MDS SAN-OS Release 3.x
iscsi virtual-target name name
advertise interface {gigabitethernet slot/port[.subinterface] | port-channel
channel-id[.subinterface]}
all-initiator-permit
initiator {initiator-name | ip-address ipaddress [netmask]} permit
pwwn pwwn-id [fc-lun number iscsi-lun number [secondary-pwwn pwwn-id [sec-lun
number]] | secondary-pwwn pwwn-id]
revert-primary-port
trespass
iscsi virtual-target name name
no advertise interface {gigabitethernet slot/port[.subinterface] | port-channel
channel-id[.subinterface]}
no all-initiator-permit
no initiator {initiator-name | ip-address ipaddress [netmask]} permit
no pwwn pwwn-id [fc-lun number iscsi-lun number [secondary-pwwn pwwn-id [sec-lun
number]] | secondary-pwwn pwwn-id]
no revert-primary-port
no trespass
no iscsi virtual-target name name
Enters the virtual target name to be used. The minimum length is 16
characters and maximum of 223 bytes.
Advertises the virtual target name on the specified interface.
Selects the Gigabit Ethernet interface or subinterface to configure.
Selects the Port Channel interface or subinterface to configure.
Enables all iSCSI initiator access to this target.
Configures specific iSCSI initiator access to this target.
Specifies the iSCSI initiator name to be used access a specified target.
Maximum length is 255 characters.
Specifies the iSCSI initiator IP address.
Specifies all initiators in the subnet.
Permits access to the specified target.
Specifies the peer WWN ID for special frames.
Specifies the secondary pWWN ID.
Specifies the Fibre Channel Logical Unit Number (LUN).
Specifies the iSCSI virtual target number.
Specifies the secondary Fibre Channel LUN.
Moves LUNs forcefully from one port to another.
Cisco MDS 9000 Family Command Reference
iscsi virtual-target name
11-95