Ficon Port Default-State Prohibit-All - Cisco MDS 9000 series Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ficon port default-state prohibit-all

To set the FICON port default state to prohibit all, use the ficon port default-state prohibit-all
command in configuration mode. To disable the feature or to revert to factory defaults, use the no form
of the command.
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
3.0(2)
Usage Guidelines You can change the default port prohibiting state to enabled in VSANs that you create and then
selectively disable port prohibiting on implmeneted ports, if desired. Only the FICON configuration files
created after you change the default have the new default setting.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example enables port prohibiting as the default for all implemented interfaces on the
switch.
switch(config)# ficon port default-state prohibit-all
The following example disables port prohibiting as the default for all implemented interfaces on the
switch.
switch(config)# no port default-state prohibit-all
Related Commands Command
show ficon port
default-state
OL-8413-07, Cisco MDS SAN-OS Release 3.x
ficon port default-state prohibit-all
no ficon port default-state prohibit-all
Modification
This command was introduced.
Description
Displays default FICON port prohibit state.
ficon port default-state prohibit-all
Cisco MDS 9000 Family Command Reference
8-61