Snmp Port - Cisco MDS 9000 series Command Reference Manual

snmp port

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
snmp port
Use the snmp port command to enable SNMP control of FICON configurations. To disable the
configuration or to revert to factory defaults, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Defaults
SNMP control of FICON configurations is enabled.
Command Modes FICON configuration submode.
Command History Release
1.3(1)
Usage Guidelines
By default, SNMP users can configure FICON parameters through the Fabric Manager application. You
can prohibit this access, if required, by issuing the no snmp port control command.
Examples The following example prohibits SNMP users from configuring FICON parameters.
switch(config)# ficon vsan 2
switch(config-ficon)# no snmp port control
The following example allows SNMP users to configure FICON parameters (default).
switch(config-ficon)# snmp port control
Related Commands Command
show ficon
ficon vsan vsan-id
Cisco MDS 9000 Family Command Reference
21-30
snmp port control
no snmp port control
Modification
This command was introduced.
Description
Displays configured FICON details.
Enables FICON on the specified VSAN.
Chapter 21 S Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x