Ficon Slot Assign Port-Numbers - Cisco MDS 9000 series Command Reference Manual

ficon slot assign port-numbers

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ficon slot assign port-numbers
To reserve FICON port numbers for a slot on the switch, use the ficon slot assign port-numbers
command in configuration mode. To release the port numbers, use the no form of the command.
Syntax Description
slot
port-numbers
Defaults
None.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
A range of 255 port numbers are available for you to assign to all the ports on a switch. You can have
more than 255 physical ports on a switch and the excess ports do not have ports numbers in the default
numbering scheme. When you have more than 255 physical ports on your switch, you can assign
unimplemented port numbers to the ports, or assign duplicate port numbers if they are not used in the
same FICON VSAN. For example, you can configure port number 1 on interface fc1/1 in FICON VSAN
10 and fc10/1 in FICON VSAN 20.
FICON port numbers are not changed for ports that are active. You must first disable the interfaces using
the shutdown command.
You can configure port numbers even when no module is installed in the slot, and before FICON is enabled
on any VSAN.
For more information on assigning port numbers, refer to "FICON Port Numbering" in the Cisco MDS
9000 Family CLI Configuration Guide or the Cisco MDS 9000 Family Fabric Manager Configuration
Guide.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example reserves FICON port numbers 0 through 15 and 48 through 63 for up to 32
interfaces in slot 3.
Cisco MDS 9000 Family Command Reference
8-62
ficon slot slot assign port-numbers [port-numbers]
no ficon slot slot assign port-numbers [port-numbers]
Specifies the slot number, 1 through 6.
Specifies the range of port numbers to assign. The range can be 0 through
153, or 0x0 through 0x99. For 9513, the port numbers can be between 0
through 249, or 0x0 through 0xf9.
Modification
This command was introduced.
Chapter 8 F Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x