Cisco MDS 9000 series Command Reference Manual page 933

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
extended credit
performance-buffers
{buffers | default}
fcrxbufsize size
mode
auto
E
F
FL
Fx
SD
ST
TL
rate-mode
dedicated
shared
speed
1000
2000
4000
auto
max 2000
trunk
allowed
vsan
add
vsan-id
all
mode
auto
off
on
mtu
off
on
duplex
auto
full
half
10
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Specifies extended receive BB_credits. The range is 256 to 4095.
Specifies receive BB_credit performance buffers. The range is 1 to 145. The
default value is determined by a built-in algorithm.
Specifies receive data field size for the interface. The range is 256 to 2112
bytes.
Configures the port mode.
Configures autosense mode.
Configures E port mode.
Configures F port mode.
Configures FL port mode.
Configures Fx port mode.
Configures SD port mode.
Configures ST port mode.
Configures TL port mode.
Configures the rate mode for an interface.
Specifies dedicated bandwidth for the port.
Specifies shared bandwidth for the port.
Configures the port speed.
Configures 1000-Mbps speed.
Configures 2000-Mbps speed.
Configures 4000-Mbps speed.
Configures autosense speed.
Configures 2-Gbps as the maximum bandwidth reserved in auto mode for
24-port and 48-port 4-Gbps switching module interfaces.
Configures trunking parameters on the interface.
Specifies the allowed list for interface(s).
Configures the VSAN range.
Adds the VSAN ID to the range of allowed VSAN list
Specifies the VSAN ID. The range is 1 to 4093.
Adds all the VSANs to allowed VSAN list.
Configures the trunking mode.
Configures automatic trunking mode.
Disables the trunking mode.
Enables the trunking mode.
Configures the maximum transmission unit (MTU) for the port.
Disables promiscuous mode.
Enables promiscuous mode.
Configures the port duplex mode.
Configures auto negotiate duplex mode.
Specifies full duplex mode
Configures half duplex mode.
Configures 10-Mbps port speed.
Cisco MDS 9000 Family Command Reference
switchport
21-65