Server (Radius Configuration) - Cisco MDS 9000 series Command Reference Manual

server (radius configuration)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
server (radius configuration)
To configure a RADIUS server, use the server command in RADIUS configuration submode. To discard
the configuration, use the no form of the command.
Syntax Description
ipv4-address
ipv6-address
name
Defaults
None.
Command Modes RADIUS configuration submode.
Command History Release
1.3(1)
3.0(1)
Usage Guidelines
None.
Examples
The following example shows the server command in RADIUS configuration submode.
switch# config terminal
switch(config)# aaa group server radius testgroup
switch(config-radius)# server myserver
Related Commands Command
radius-server host
show radius-server
Cisco MDS 9000 Family Command Reference
21-20
server [ipv4-address | ipv6-address | dns-name]
no server [ipv4-address | ipv6-address | dns-name]
Specifies the RADIUS server IP address in the format A.B.C.D.
Specifies the RADIUS server IP address in the format X:X::X.
Specifies the RADIUS DNS server name. The maximum size is 255.
Modification
This command was introduced.
Added the ipv6-address argument.
Description
Configures RADIUS server parameters.
Displays RADIUS server configuration parameters.
Chapter 21 S Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x