Deadtime (Tacacs+ Group Configuration) - Cisco MDS 9000 series Command Reference Manual

deadtime (tacacs+ group configuration)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
deadtime (tacacs+ group configuration)
To configure a periodic time interval where a nonreachable (nonresponsive) TACACS+ server is
monitored for responsiveness, use the deadtime command in TACACS+ group configuration submode.
To disable the monitoring of the nonresponsive server, use the no form of the command.
Syntax Description time
Defaults
Zero.
Command Modes TACACS+ group configuration submode.
Command History Release
3.0(1)
Usage Guidelines
If the dead time interval for an individual TACACS+ server is greater than zero (0), that value takes
precedence over the value set for the server group.
When the dead time interval is 0 minutes, TACACS+ server monitoring is not performed unless the
TACACS+ server is part of a server group and the dead time interval for the group is greater than 0
minutes.
Examples The following example shows the deadtime command in TACACS+ group configuration submode.
switch# config terminal
switch(config)# aaa group server tacacs mygroup
switch(config-tacacs)# deadtime 5
Related Commands Command
tacacs-server
deadtime
show tacacs-server
Cisco MDS 9000 Family Command Reference
5-4
deadtime time
no deadtime time
Specifies the time interval (in minutes) for monitoring the server. The time
range is 1 to 1440 minutes.
Modification
This command was introduced.
Description
Sets a time interval for monitoring a nonresponsive TACACS+ server.
Displays TACACS+ server information.
Chapter 5 D Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x