Ip Address (Fcip Profile Configuration Submode) - Cisco MDS 9000 series Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ip address (FCIP profile configuration submode)

To assign the local IP address of a Gigabit Ethernet interface to the FCIP profile, use the ip address
command. To remove the IP address, use the no form of the command.
Syntax Description
address
Defaults Disabled.
Command Modes FCIP profile configuration submode.
Command History Release
1.3(1)
Usage Guidelines To create a FCIP profile, you must assign a local IP address of a Gigabit Ethernet interface to the FCIP
profile.
Examples
The following example assigns the local IP address of a Gigabit Ethernet interface to the FCIP profile.
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)# ip address 10.5.1.1
Related Commands Command
show fcip profile
interface fcip
interface_number
use-profile profile-id
show interface fcip
OL-8413-07, Cisco MDS SAN-OS Release 3.x
ip address address
no ip address address
Specifies the IP address.
Modification
This command was introduced.
Description
Displays information about the FCIP profile.
Configures the interface using an existing profile ID from 1 to 255.
Displays an interface configuration for a specified FCIP interface.
ip address (FCIP profile configuration submode)
Cisco MDS 9000 Family Command Reference
11-43