Match Address - Cisco MDS 9000 series Command Reference Manual

match address

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
match address
To configure match addresses in an IPsec crypto map with an access control list (ACL), use the match
address command in IPsec crypto map configuration submode. To not match addresses, use the no form
of the command.
Syntax Description acl-name
Defaults None.
Command Modes
IPsec crypto map configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples
The following example shows how to match addresses in an IPsec crypto map with an ACL.
switch# config terminal
switch(config)# crypto map domain ipsec x 1
switch(config-crypto-map-ip)# match address UserACL
Related Commands Command
crypto ike domain ipsec
crypto ike enable
show crypto map domain ipsec Displays IPsec crypto map information.
Cisco MDS 9000 Family Command Reference
15-4
match address acl-name
no match address [acl-name]
Specifies the ACL name. Maximum length is 64 characters.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Chapter 15 M Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x