Qos Service - Cisco MDS 9000 series Command Reference Manual

qos service

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
qos service
To apply a service policy, use the qos service command in configuration mode. To remove a
previously-configured class, use the no form of the command.
Syntax Description
policy policy-name
vsan vsan-id
Defaults None.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines
You can access this command only if you enable the QoS data traffic feature using the qos enable
command.
Examples The following example applies a configured policy to VSAN 3.
switch(config)# qos service policy MyPolicy vsan 3
Operation in progress. Please check policy-map parameters
The following example deletes a configured policy that was applied to VSAN 7.
switch(config)# no qos service policy OldPolicy vsan 7
Operation in progress. Please check policy-map parameters
Related Commands Command
show qos
Cisco MDS 9000 Family Command Reference
19-8
qos service policy policy-name vsan vsan-id
no qos service policy policy-name vsan vsan-id
Modification
This command was introduced.
Description
Displays configured QoS information.
Associates a policy map with the VSAN.
Specifies the VSAN ID. The range is 1 to 4093.
Chapter 19 Q Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x