Fcsp Timeout - Cisco MDS 9000 series Command Reference Manual

fcsp timeout

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fcsp timeout
To configure the timeout value for FC-SP message, use the fcsp timeout command in configuration
mode. Use the no form of the command to revert to factory defaults.
Syntax Description
timeout-period
Defaults 30 seconds
Command Modes
Configuration mode.
Command History Release
1.3(1)
Usage Guidelines You can only see the fcsp timeout command if you issue the fcsp enable command.
Examples
The following example configures the FCSP timeout value.
switch# config terminal
switch(config)# fcsp enable
switch(config)# fcsp timeout 60
Related Commands Command
fcsp enable
show fcsp
Cisco MDS 9000 Family Command Reference
8-50
fcsp timeout timeout-period
no fcsp timeout timeout-period
Specifies the time out period. The time ranges from 20 to 100 seconds. The
default is 30 seconds.
Modification
This command was introduced.
Description
Enable FC-SP.
Displays configured FC-SP information.
Chapter 8 F Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x