Fcs Virtual-Device-Add - Cisco MDS 9000 series Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fcs virtual-device-add

To include a virtual device in a query about zone information from an FCS, use the fcs
virtual-device-add command in configuration mode. To remove a virtual device, use the no form of the
command.
Syntax Description vsan-ranges vsan-ids
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
3.1(2)
Usage Guidelines VSAN ranges are entered as vsan-ids-vsan-ids. When you specify more than one range, separate each
range with a comma. If no range is specified, the command applies to all VSANs.
Examples The following example shows how to add to one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4
The following example shows how to add to more than one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4,5-8
Related Commands Command
show fcs
OL-8413-07, Cisco MDS SAN-OS Release 3.x
fcs virtual-device-add [vsan-ranges vsan-ids]
no fcs virtual-device-add [vsan-ranges vsan-ids]
Specifies one or multiple ranges of VSANs. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays fabric configuration server information.
Cisco MDS 9000 Family Command Reference
fcs virtual-device-add
8-43