Cisco MDS 9000 series Command Reference Manual page 713

Chapter 14 L Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The following example assigns the user-specified initialization string for a Supervisor-2 module to its
corresponding profile.
switch# config terminal
switch(config)# line com1
switch(config-com1)# modem set-string user-input ATE0Q0V1&D0&C0S0=1
The following example deletes the configured initialization string.
switch# config terminal
switch(config)# line com1
switch(config-com1)# no modem set-string user-input ATE0Q1&D2&C1S0=3\015
The following example writes the user-specified initialization string to the modem.
switch# config terminal
switch(config)# line com1
switch(config-com1)# modem init-string user-input
Related Commands Command
line console
line vty
show line com1
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Description
Configure primary terminal line.
Configure virtual terminal line.
Displays COM1 information.
Cisco MDS 9000 Family Command Reference
line com1
14-5