Cisco MDS 9000 series Command Reference Manual page 873

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command History Release
2.1(1a)
3.0(1)
Usage Guidelines To access this command, you must first enable the SANTap feature on the SSM using the ssm enable
feature command.
When the lun-size-handling option is set (enabled), the maximum logical block addressing (LBA) for
DVT LUN is set to 2 TB. As a result, there is no issue with LUN resizing.
You can delete dvt target-pwwn using the no santap module slot dvt target-pwwn command. Other
Note
dvt options are not supported by the no form of the command.
Examples
The following example shows the configuration of the SSM where the SANTap feature is enabled and
the VSAN used to communicate with the appliance.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# santap module 1 appl-vsan 1
Related Commands Command
ssm enable feature
show santap module
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Modification
This command was introduced.
Added the following options: cvt-name, dvt, target-pwwn, target-vsan,
dvt-name, dvt-vsan, dvt-port, lun-size-handling, and io-timeout.
Description
Enables the SANTap feature on the SSM.
Displays the configuration and statistics of the SANTap feature.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
santap module
21-5