Port - Cisco MDS 9000 series Command Reference Manual

Chapter 18 P Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

port

To assign the TCP port number of a Gigabit Ethernet interface to the FCIP profile or a listener peer port
for a ISCSI interface, use the port command. Use the no form of the command to negate the command
or revert to factory defaults.
Syntax Description port number
Defaults Disabled
Command Modes
Fcip profile configuration submode.
Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines Associates the profile with the assigned local port number. If a port number is not assigned for a FCIP
profile, the default TCP port 3225 is used.
Examples
The following example configures port 5000 on FCIP interface 5.
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)# port 5000
The following example configures port 4000 on ISCSI interface 2/1.
switch# config terminal
switch(config)# interface iscsi 2/1
switch(config-profile)# port 4000
Related Commands Command
show fcip profile
interface fcip
interface_number
use-profile profile-id
show interface fcip
OL-8413-07, Cisco MDS SAN-OS Release 3.x
port number
no port number
Configures a peer port. The range is 1 to 65535.
Modification
This command was introduced.
Description
Displays information about the FCIP profile.
Configures the interface using an existing profile ID from 1 to 255.
Displays an interface configuration for a specified FCIP interface.
Cisco MDS 9000 Family Command Reference
port
18-13