Lifetime Seconds - Cisco MDS 9000 series Command Reference Manual

lifetime seconds

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
lifetime seconds
To configure the security association (SA) lifetime duration for an IKE protocol policy, use the lifetime
seconds command in IKE policy configuration submode. To revert to the default, use the no form of the
command.
Syntax Description seconds
Defaults 86,400 seconds.
Command Modes
IKE policy configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
The lifetime seconds command overrides the default.
Examples The following example shows how to configure the SA lifetime duration for the IKE protocol.
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# policy 1
switch(config-ike-ipsec-policy)# lifetime seconds 6000
Related Commands Command
crypto ike domain ipsec
crypto ike enable
policy
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
14-2
lifetime seconds seconds
no lifetime [seconds seconds]
Specifies the lifetime duration in seconds. The range is 600 to 86400.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Configures IKE protocol policy.
Chapter 14 L Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x