Cisco MDS 9000 series Command Reference Manual page 667

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
A Gigabit Ethernet interface configured for iSLB can only be in one VRRP group because redirected
Caution
sessions do not carry information about the VRRP IP address or group. This restriction allows the slave
port to uniquely identify the VRRP group to which it belongs.
Caution Changing the VSAN membership, the forwarding mode, and the authentication of an iSCSI interface that
is part of an iSLB VRRP group impacts load balancing on the interface.
For additional information, refer to the "Configuring iSCSI" chapter of the Cisco MDS 9000 Family CLI
Configuration Guide.
Examples The following example enables VRRP load balancing for IPv4 Virtual Router group 20.
switch# config t
switch(config)# islb vrrp 20 load-balance
The following example disables VRRP load balancing for IPv4 Virtual Router group 20.
switch(config)# no islb vrrp 20 load-balance
The following example enables VRRP load balancing for IPv6 Virtual Router group 30.
switch(config)# islb vrrp ipv6 30 load-balance
The following example disables VRRP load balancing for IPv6 Virtual Router group 30.
switch(config)# no islb ipv6 30 load-balance
Related Commands Command
show islb session
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Description
Displays detailed iSLB session information.
Cisco MDS 9000 Family Command Reference
islb vrrp
11-109