Attach - Cisco MDS 9000 series Command Reference Manual

attach

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
attach
To connect to a specific module, use the attach command in EXEC mode.
Syntax Description
module slot-number
Defaults None.
Command Modes EXEC mode.
Command History Release
1.0(2)
Usage Guidelines You can use the attach module command to view the standby supervisor module information, but you
cannot configure the standby supervisor module using this command.
You can also use the attach module command on the switching module portion of the Cisco MDS 9216
supervisor module, which resides in slot 1 of this two-slot switch.
To disconnect, use the exit command at the
attach session.
Examples The following example connects to the module in slot 2. Note that after you connect to the image on the
module using the attach module command, the prompt changes to module-number#.
switch# attach module 1
Attaching to module 1 ...
To exit type 'exit', to abort type '$.'
module-1# exit
switch#
Related Commands Command
exit
show module
Cisco MDS 9000 Family Command Reference
2-16
attach module slot-number
Specifies the slot number of the module.
Modification
This command was introduced.
Description
Disconnects from the module.
Displays the status of a module.
prompt, or type
module-number#
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
. to forcibly abort the
$