Autonomous-Fabric-Id (Ivr Service Group Configuration) - Cisco MDS 9000 series Command Reference Manual

Chapter 2 A Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

autonomous-fabric-id (IVR service group configuration)

To configure an autonomous fabric ID (AFID) into an IVR service group, use the autonomous-fabric-id
command in IVR service group configuration submode. To remove the autonomous fabric ID, use the no
form of the command.
Syntax Description afid
vsan-ranges vsan-id
Defaults
None.
Command Modes IVR service group configuration submode.
Command History Release
2.1
Usage Guidelines
Before configuring an IVR service group, you must enable the following:
•
•
•
To change to IVR service group configuration submode, use the ivr service-group activate command.
Examples The following command enters the IVR service group configuration submode and configures AFID 10
to be in IVR service group serviceGroup1.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# ivr enable
switch(config)# ivr distribute
switch(config)# ivr vsan-topology auto
switch(config)# ivr service-group name serviceGroup1
switch(config-ivr-sg)# autonomous-fabric-id 10 vsan 1-4
OL-8413-07, Cisco MDS SAN-OS Release 3.x
autonomous-fabric-id afid vsan-ranges vsan-id
no autonomous-fabric-id afid vsan-ranges vsan-id
Modification
This command was introduced.
IVR using the ivr enable command
IVR distribution using the ivr distribute command
Automatic IVR topology discovery using the ivr vsan-topology auto command
autonomous-fabric-id (IVR service group configuration)
Specifies the AFID to the local VSAN.
Configures up to five ranges of VSANs to be added to the service
group. The range is 1 to 4093.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
2-23