Debug Callhome - Cisco MDS 9000 series Command Reference Manual

Chapter 6 Debug Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

debug callhome

To enable debugging for the Call Home function, use the debug callhome command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
Syntax Description all
events
mts
Defaults Disabled.
Command Modes EXEC mode.
Command History Release
1.0(2)
Usage Guidelines The debug callhome command, when used with the all parameter, displays the troubleshooting
information for both Call Home event traces and a dump of the messaging and transaction service (MTS)
messages that the Call Home function receives.
Note The debug Call Home function displays event traces for both successful and unsuccessful Call Home
e-mail transmissions.
OL-8413-07, Cisco MDS SAN-OS Release 3.x
debug callhome {all | events | mts}
no debug callhome {all | events | mts}
Modification
This command was introduced.
Enables debugging for all Call Home features.
Enables debugging for all Call Home events.
Enables debugging for all Call Home tx/rx packets of MTS
Cisco MDS 9000 Family Command Reference
debug callhome
6-7