Logging Timestamp - Cisco MDS 9000 series Command Reference Manual

logging timestamp

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
logging timestamp
To set the time increment for the message logging time stamp, use the logging timestamp command. To
negate the previously issued command or to revert to factory defaults, use the no form of the command.
Syntax Description
microseconds
milliseconds
seconds
Defaults
Seconds.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
None.
Examples The following example sets the logging time stamp to milliseconds.
switch
switch(config)# logging timestamp milliseconds
Related Commands Command
show logging
Cisco MDS 9000 Family Command Reference
14-22
logging timestamp {microseconds | milliseconds | seconds}
no logging timestamp {microseconds | milliseconds | seconds}
Sets the logging time stamp to microseconds.
Sets the logging time stamp to milliseconds.
Sets the logging time stamp to seconds.
Modification
This command was introduced.
#
# config terminal
Description
Displays logging configuration information.
Chapter 14 L Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x