Debug Tlport - Cisco MDS 9000 series Command Reference Manual

Chapter 6 Debug Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

debug tlport

To enable debugging for TL port interfaces, use the debug tlport command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
Syntax Description all
errors
events
fc2
terminal
transit
mts
pss
interface fc slot/port
Defaults
Disabled.
Command Modes
EXEC mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples
The following example displays the system output when the debug tlport events pss command is issued:
switch# debug tlport events pss
Related Commands Command
no debug all
show tlport
OL-8413-07, Cisco MDS SAN-OS Release 3.x
debug tlport {all | errors | events {fc2 {terminal | transit} | mts | pss}} [interface fc slot/port]
no debug tlport {all | errors | events {fc2 {terminal | transit} | mts | pss}} [interface fc slot/port]
Modification
This command was introduced.
Description
Disables all debugging.
Displays configured TL port information.
Enables debugging for all TL port features.
Enables debugging for TL port error conditions.
Enables debugging for TL port monitoring events.
Enables debugging for TL port monitoring FC 2 events.
Specifies TL port monitoring FC 2 terminating events.
Specifies TL port monitoring FC 2 transit events.
Enables debugging for TL port monitoring MTS packets.
Enables debugging for TL port monitoring PSS packets.
Restricts debugging to the specified interface.
Cisco MDS 9000 Family Command Reference
debug tlport
6-121