Alert-Group - Cisco MDS 9000 series Command Reference Manual

Chapter 2 A Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

alert-group

To customize a Call Home alert group with user-defined show commands, use the alert-group command
in Call Home configuration submode. To remove the customization, user the no form of the command.
Syntax DescriptionT
event-type
Avanti
Environmental
Inventory
License
RMON
Supervisor-Hardware
Syslog-group-port
System
test
user-def-cmd command Configures a CLI command for an alert-group. The maximum size is 512.
Defaults None.
Command Modes Call Home configuration submode.
Command History Release
3.0(1)
Usage Guidelines
The user-def-cmd argument allows you to define a command whose outputs should be attached to the
callhome message being sent. Only show commands can be specified and they must be associated with
an alert group. Five commands can be specified per alert group. Invalid commands are rejected.
Note Make sure the destination profiles for the non-Cisco-TAC alert group, with a predefined show command,
and the Cisco-TAC alert group are not the same.
Examples
The following example configures a user-defined command, called show license usage, for an alert
group license.
switch(config-callhome)# alert-group license user-def-cmd "show license usage"
OL-8413-07, Cisco MDS SAN-OS Release 3.x
alert-group event-type user-def-cmd command
no alert-group event-type user-def-cmd command
Specifies event types by the following alert groups.
Displays Avanti events.
Displays power, fan, and temperature related events.
Displays inventory status events.
Displays events related to licensing.
Displays events related to Remote Monitoring (RMON).
Displays supervisor related events.
Displays events relate to syslog messages filed by the the port manager.
Displays software related events.
Displays user-generated test events.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
alert-group
2-13