Crypto Ike Enable - Cisco MDS 9000 series Command Reference Manual

crypto ike enable

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
crypto ike enable
To enable IKE, use the crypto ike enable command. To disable IKE, use the no form of the command.
Syntax Description This command has no other arguments or keywords.
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
2.0(x)
Usage Guidelines The IKE protocol cannot be disabled unless IPsec is disabled.
The configuration and verification commands for the IKE protocol are only available when the IKE
protocol is enabled on the switch. When you disable this feature, all related configurations are
automatically discarded.
This command is not supported on the Cisco MDS 9124 switch.
Note
Examples The following example shows how to enable the IKE protocol.
switch# config terminal
switch(config)# crypto ike enable
Related Commands Command
clear crypto ike domain ipsec
sa
crypto ipsec enable
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
4-122
crypto ike enable
no crypto ike enable
Modification
This command was introduced.
Description
Clears IKE protocol information clear IKE SAs.
Enables IPsec.
Chapter 4 C Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x