Nasb Module - Cisco MDS 9000 series Command Reference Manual

nasb module

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
nasb module
To enable Network-Accelerated Serverless Backup (NASB) in a VSAN and map it to the Storage
Services Module (SSM) where the feature is enabled, use the nasb module command in configuration
mode. To disable this feature, use the no form of the command.
Syntax Description slot-number
vsan vsan-id
control
multiple
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
2.1(1a)
2.1(2)
Usage Guidelines This feature must be enabled on the SSM using the ssm enable feature command before you can
configure NASB.
Examples
The following example configures NASB on the SSM installed in slot 4 with a link to VSAN 1.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# nasb module 4 vsan 1
The following example configures NASB on the SSM installed in slot 4 with a link to VSAN 10, and
enables a single target LUN that is a Storage Array Controller (Peripheral Device Type = 0x0C).
switch# config terminal
Enter configuration commands, one per line.
switch(config)# nasb module 4 vsan 10 control
Cisco MDS 9000 Family Command Reference
16-2
nasb module slot-number vsan vsan-id [control [multiple] | multiple [control]]
no nasb module slot-number vsan vsan-idr
Specifies the slot number of the connected module.
Configures up to five VSANs to be added to the database. The range is 1 to
4096.
Configures a single target LUN that is a Storage Array Controller (Peripheral
Device Type 0x0C).
Configures up to 10 target LUNs that are the default type, Direct Access
Device (Peripheral Device Type 0x00).
Modification
This command was introduced.
Added the multiple option.
End with CNTL/Z.
End with CNTL/Z.
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 16 N Commands