Arp - Cisco MDS 9000 series Command Reference Manual

Chapter 2 A Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

arp

To enable the Address Resolution Protocol (ARP) for the switch, use the arp command.To disable ARP
for the switch, use the no form of the command.
Syntax Description
hostname
Defaults Enabled.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples The following example disables the Address Resolution Protocol configured for the host with the IP
address 10.1.1.1.
switch(config)# no arp 10.1.1.1
switch(config)#
Related Commands Command
show arp
clear arp
OL-8413-07, Cisco MDS SAN-OS Release 3.x
arp hostname
no arp hostname
Specifies the name of the host. Maximum length is 20 characters.
Modification
This command was introduced.
Description
Displays the ARP table.
Deletes a specific entry or all entries from the ARP table.
Cisco MDS 9000 Family Command Reference
arp
2-15