Ivr Vsan-Topology - Cisco MDS 9000 series Command Reference Manual

ivr vsan-topology

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ivr vsan-topology
To configure manual or automatic discovery of the Inter-VSAN Routing (IVR) topology, use the
ivr vsan-topology command in configuration mode.
Syntax Description activate
auto
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
1.3(1)
2.1(1a)
Usage Guidelines
To use this command you must first enable IVR using the ivr enable command and configure the IVR
database using the ivr vsan-topology database command.
Caution Active IVR topologies cannot be deactivated. You can only switch to automatic topology discovery
mode.
Examples The following ivr vsan-topology activate command activates the VSAN topology database:
switch# config terminal
Enter configuration commands, one per line.
switch(config)# ivr enable
switch(config)# ivr vsan-topology database
switch(config-ivr-topology-db)# autonomous-fabric-id 1 switch 20:00:00:00:30:00:3c:5e
vsan-ranges 2,2000
switch(config)# ivr vsan-topology activate
The following command enables VSAN topology database auto mode, which allows the switch to
automatically discover the IVR topology.
switch(config)# ivr vsan-topology auto
Cisco MDS 9000 Family Command Reference
11-134
ivr vsan-topology {activate | auto}
Configures manual discovery of the IVR topology and disables automatic
discovery mode.
Configures automatic discovery of the IVR topology.
Modification
This command was introduced.
Added auto keyword.
End with CNTL/Z.
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands