Ivr Zoneset - Cisco MDS 9000 series Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ivr zoneset

To configure a zoneset for Inter-VSAN Routing (IVR), use the ivr zoneset command. To revert to the
factory defaults, use the no form of the command.
Syntax Description
activate
force
name ivzs-name
Defaults
None.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines
This command enters IVR zoneset configuration submode.
Examples The following command enters the configuration mode, enables the IVR feature, creates an IVZS, adds
a IVZ member, and activates the IVZS.
switch# config terminal
switch(config)# ivr enable
switch(config)# ivr zoneset name Ivr_zoneset1
switch(config-ivr-zoneset)# member Ivz_vsan2-3
switch(config-ivr-zoneset)# exit
switch(config)# ivr zoneset activate name IVR_ZoneSet1
Related Commands Command
show ivr
OL-8413-07, Cisco MDS SAN-OS Release 3.x
ivr zoneset {activate name ivzs-name [force] | name ivzs-name}
no ivr zoneset {activate name ivzs-name [force] | name ivzs-name}
Activates a previously-configured IVZS.
Forces a IVZS activation
Specifies the IVZS name. Maximum length is 59 characters.
Modification
This command was introduced.
Description
Displays IVR feature information.
Cisco MDS 9000 Family Command Reference
ivr zoneset
11-141