Debug Ipconf - Cisco MDS 9000 series Command Reference Manual

debug ipconf

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug ipconf
To enable IP configuration debugging, use the debug ipconf command in EXEC mode. To disable a
debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
Syntax Description all
errors
events
info
pss
Defaults Disabled.
Command Modes EXEC mode.
Command History Release
1.0(2)
Usage Guidelines
None.
Examples The following example displays the system output when the debug ipconf all command is issued:
switch# debug ipconf all
switch# 2005 Mar 10 02:45:30 ipconf: Received MTS message
2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27
2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000
2005 Mar 10 02:45:30 ipconf: Received MTS message
2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27
2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000
2005 Mar 10 02:45:30 ipconf: Received MTS message
2005 Mar 10 02:45:30 ipconf: MTS message received opcode 862 source 0x00000601/27
2005 Mar 10 02:45:30 ipconf: Getting ip addresses on interface 5000000
Related Commands Command
no debug all
Cisco MDS 9000 Family Command Reference
6-64
debug ipconf {all | errors | events | info | pss}
no debug ipconf {all | errors | events | info | pss}
Modification
This command was introduced.
Description
Disables all debugging.
Enables debugging for all IP configuration features.
Enables debugging for IP configuration error conditions.
Enables debugging for IP configuration tx/rx MTS events.
Enables debugging for IP configuration information.
Enables debugging for IP configuration PSS operations.
Chapter 6 Debug Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x