Startup; Warning Messages; Figure 3-23: Warning Messages - Teledyne T100 Instruction Manual

Teledyne ML - T100 UV Fluorescence SO2 Analyzer

3.6.1. STARTUP

3.6.2. WARNING MESSAGES

Suppresses the
warning messages
NOTE:
If a warning message persists after
several attempts to clear it, the message
may indicate a real problem and not an
artifact of the warm-up period
Once the last warning has
been cleared, the RANGE
function will be displayed in
the analyzer's main
MESSAGE FIELD.
After the electrical and pneumatic connections are made, an initial functional check is in
order. Turn on the instrument. The pump and exhaust fan should start immediately.
The display will show a momentary splash screen of the Teledyne ML logo and other
information during the initialization process while the CPU loads the operating system,
the firmware and the configuration data.
The analyzer should automatically switch to Sample Mode after completing the boot-up
sequence and start monitoring the gas. However, there is an approximately one hour
warm-up period before reliable gas measurements can be taken. During the warm-up
period, the front panel display may show messages in the Parameters field.
Because internal temperatures and other conditions may be outside be specified limits
during the analyzer's warm-up period, the software will suppress most warning
conditions for 30 minutes after power up. If warning messages persist after the 60
minutes warm up period is over, investigate their cause using the troubleshooting
guidelines in Section 10.1.1.
To view and clear warning messages, press:
SAMPLE
TEST
SAMPLE
TEST
SAMPLE
TEST
SYSTEM
TEST
STANDBY
TEST
Figure 3-23:
Table 3-13 lists brief descriptions of the warning messages that may occur during start
up for T100 analyzers with no options installed.
SYSTEM RESET
CAL MSG CLR SETUP
SYSTEM RESET
CAL MSG CLR SETUP
SYSTEM RESET
CAL MSG CLR SETUP
SYSTEM RESET
CLR SETUP
RANGE=500.0 PPB SO2=XXXX
CAL MSG SETUP
Warning Messages
Getting Started
MSG returns the active
warnings to the message
field.
Press CLR to clear the current
message.
If more than one warning is
active, the next message will take
its place.
67