Table of Contents
Advertisement
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
4.8.2. SIGNAL I/O
IMPORTANT
The signal I/O diagnostic mode allows a user to review and change the digital and
analog input/output functions of the analyzer. Refer to Appendix A-4 for a complete list
of the parameters available for review under this menu.
Any changes of signal I/O settings will remain in effect only until the signal I/O menu is
exited. Exceptions are the ozone generator override and the flow sensor calibration,
which remain as entered when exiting.
Access the signal I/O test mode from the DIAG Menu (refer to Figure 4-17), then press:
DIAG
SIGNAL I / O
PREV NEXT
JUMP
DIAG I / O
0) EXT_ZERO_CAL=OFF
PREV NEXT
JUMP
EXAMPLE
DIAG I / O
JUMP TO: 12
1
2
DIAG I / O
12) ST_SYSTEM_OK = ON
PREV NEXT JUMP
Toggle ON/(OFF) button to
change status.
Figure 4-18:
Use the NEXT & PREV
keys to move between
ENTR
EXIT
Use the JUMP key to
PRNT EXIT
See Appendix A-4 for
ENTR
EXIT
12) ST_SYSTEM_OK=ON
ON
PRNT
EXIT
Pressing the PRNT BUTTONwill send a
formatted printout to the serial port and can be
captured with a computer or other output device.
DIAG – Signal I/O Menu
Operating Instructions
signal types.
go directly to a
specific signal
a complete list of
available SIGNALS
EXAMPLE:
Enter 12 to Jump to
Exit to return
to the
DIAG menu
103
Advertisement
Table of Contents
