Specifications, Approvals & Compliance; Specifications And Approvals - Teledyne T100 Instruction Manual

2.
SPECIFICATIONS, APPROVALS & COMPLIANCE

2.1. SPECIFICATIONS AND APPROVALS

Parameter
Ranges
(Physical Analog Output)
Measurement Units
1
Zero Noise
1
Span Noise
2
Lower Detectable Limit
Zero Drift)
Span Drift
1
Lag Time
1
Rise/Fall Time
Linearity
1
Precision
Sample Flow Rate
Power Requirements
Analog Output Ranges
Recorder Offset
Standard I/O
Optional I/O
This section presents specifications for the T100 analyzer and the O
options, Agency approvals, EPA equivalency designation, and CE mark compliance.
Table 2-1: T100 Basic Unit Specifications
Min: 0-50 ppb Full Scale
Max: 0-20,000 ppb Full Scale (selectable, dual ranges and auto ranging supported)
3
ppb, ppm, µg/m , mg/m
0.2 ppb (RMS)
<
0.5% of reading, above 50 ppb
<
0.4 ppb
0.5 ppb/24 hours
<
0.5% of full scale/24 hours
<
20 seconds
<100 sec to 95%
1% of full scale
0.5% of reading above 50 ppb
3
650 cm /min. ±10%
100V-120V, 220V-240 V, 50/60 Hz
10 V, 5 V, 1 V, 0.1 V (selectable)
± 10 %
1 Ethernet: 10/100Base-T
2 RS-232 (300 – 115,200 baud)
2 USB device ports
8 opto-isolated digital outputs
6 opto-isolated digital inputs
4 analog outputs
1 USB com port
1 RS485
8 analog inputs (0-10V, 12-bit)
4 digital alarm outputs
Multidrop RS232
3 4-20mA current outputs
Description
3
(selectable)
and CO sensor
2 2
29