Teledyne T100 Instruction Manual page 142

Remote Operation & Advanced Features
5.2.2.2. EDITING DAS DATA CHANNELS
EXIT will return to the
previous SAMPLE
display.
Moves the
display up &
down the list of
Data Channels
Inserts a new Data
Channel into the list
BEFORE the Channel
currently being displayed
Moves the display
between the
PROPERTIES for this
data channel.
Allows to edit the channel name, see next key sequence.
142
Although IDAS configuration is most conveniently done through the APICOM remote
control program (refer to Section 6.12.2.8), the following illustrations shows how to edit
DAS channels using the analyzer's front panel control buttons.
SAMPLE RANGE = 500.000 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE
Main Data Acquisition Menu
SETUP X.X
VIEW EDIT
SETUP X.X 0) CONC1: ATIMER, 2, 4032, RS-232
PREV NEXT
Deletes The Data
Channel currently
being displayed
SETUP X.X NAME:CONC1
<SET SET> EDIT PRNT
DAS – Editing DAS Data Channels
Figure 5-11:
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
SO2 =XXX.X
ENTR
DATA ACQUISITION
Edit Data Channel Menu
INS DEL EDIT PRNT
Reports the configuration of current
data channels to the RS-232 ports.
SETUP
EXIT
EXIT
EXIT
Exits to the Main
Data Acquisition
EXIT
Menu
Exports the
configuration of all
data channels to
RS-232 interface.
Exits returns to the
previous Menu
EXIT