Maintenance Schedule - Teledyne T100 Instruction Manual

8.1. MAINTENANCE SCHEDULE

Table 8-1 is the recommended maintenance schedule for the T100. Please note that in certain environments with high levels of
dust, humidity or pollutant levels some maintenance procedures may need to be performed more often than shown.
ITEM ACTION
Change particle
1
Particulate filter
filter
Review and
Verify test functions
evaluate
Evaluate offset
Zero/span check
and slope
Zero and span
1
Zero/span calibration
calibration
1
External zero air Exchange
scrubber (optional) chemical
1
Perform flow check Check Flow
Internal IZS
Replace
Permeation Tube
Perform pneumatic Verify Leak Annually or after repairs
leak check Tight
2
Pump diaphragm Replace
Calibrate UV Lamp Perform LAMP
Output CAL
Low-level
3
PMT sensor
hardware
hardware calibration
calibration
Clean
1
Sample chamber chamber,
optics windows and
filters
1
Critical flow orifice &
Replace
sintered filters
1
These Items are required to maintain full warranty; all other items are strongly recommended.
2
A pump rebuild kit is available from Teledyne ML's Customer Service including all instructions and required parts (refer to Appendix B for part numbers).
3
Replace desiccant bags each time the inspection plate for the sensor assembly is removed.
Table 8-1: T100 Preventive Maintenance Schedule
CAL MANUAL
FREQUENCY
CHECK SECTION
Weekly No
8.2; Appendix
Weekly No
Weekly -- 6.3, 6.6, 6.9
6.2, 6.4, 6.5,
Every 3 months --
6.7, 6.8
Every 3 months No
Every 6 Months No
Annually YES
Yes
involving pneumatics
Refer to
Annually Yes diaphragm kit
instructions
Prior to zero/span
4.8.7 &
calibration or PMT --
10.7.2.5
hardware calibration
On PMT/ preamp
changes if
Yes 10.7.2.8
0.7 < SLOPE or
SLOPE >1.3
10.7.2.2 &
As necessary Yes
10.7.2.3
As necessary Yes
8.3.1
C
8.3.3
8.3.7
8.3.2
8.3.6
8.3.4
211
DATE PERFORMED