Startup, Functional Checks, And Initial Calibration; Startup; Warning Messages; Figure 3-24: Warning Messages - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
3.4. STARTUP, FUNCTIONAL CHECKS, AND INITIAL
CALIBRATION
3.4.1.

STARTUP

3.4.2.

WARNING MESSAGES

Suppresses the
warning messages
NOTE:
If a warning message persists after
several attempts to clear it, the message
may indicate a real problem and not an
artifact of the warm-up period
Once the last warning has been cleared,
the RANGE function will be displayed in
the analyzer's Param field.
06807F DCN7335
Analyzer
2
If you are unfamiliar with the T100 principles of operation, we recommend that you
read Section 12. For information on navigating the analyzer's software menus, refer to
the menu trees provided in Appendix A.
CAUTION - GENERAL SAFETY HAZARD
Do not look at the UV lamp while the unit is operating. UV light can
cause eye damage. Always use safety glasses made from UV blocking
material whenever working with the UV Lamp. (Generic plastic glasses
are not adequate).
After the electrical and pneumatic connections are made, run an initial functional
check. Turn on the instrument. The pump and exhaust fan should start immediately.
The display will show a momentary splash screen of the Teledyne API logo and other
information during the initialization process while the CPU loads the operating system,
the firmware and the configuration data.
The analyzer should automatically switch to Sample Mode after completing the boot-up
sequence and start monitoring the gas. However, there is an approximately one hour
warm-up period before reliable gas measurements can be taken. During the warm-up
period, the front panel display may show messages in the Parameters field.
Because internal temperatures and other conditions may be outside the specified limits
during the analyzer's warm-up period, the software will suppress most warning
conditions for 30 minutes after power up. If warning messages persist after the 60
minutes warm up period is over, investigate their cause using the troubleshooting
guidelines in Section 11.1.1.
To view and clear warning messages, press:
SAMPLE
TEST
SAMPLE
<TST TST>
SAMPLE
TEST
SAMPLE
<TST TST>
Figure 3-24:
SYSTEM RESET
CAL CLR SETUP
RANGE=500.0 PPB
CAL MSG SETUP
SYSTEM RESET
CAL CLR SETUP
RANGE=500.0 PPB
CAL SETUP
Warning Messages
Getting Started
MSG returns the active
warnings to the message
field.
Press CLR to clear the current
message.
(If more than one warning is
active, the next message will
take its place until all warning
messages have been cleared.)
65