Teledyne T100 Instruction Manual page 194

Calibration Procedures
6.10.2.2. SET CO SPAN GAS CONCENTRATION
2
SAMPLE RANGE=50.0 PPM
< TST TST > CAL
SAMPLE GAS TO CAL:CO
SO2 CO2 O2
SAMPLE GAS TO CAL:O2
SO2 CO2 O2
194
Set the expected CO span gas concentration.
2
This should be equal to the percent concentration of the CO
reporting range (default factory setting = 12%).
SO2= XX.XX
SETUP
M-P CAL
ENTR EXIT
M-P CAL
ENTR EXIT
The CO span concentration value automatically defaults
2
to 12 %.
If this is not the the concentration of the span gas being
used, toggle these buttons to set the correct concentration
of the CO calibration gases.
2
Figure 6-18: CO
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
RANGE=50.0 PPM
<TST TST> ZERO SPAN CONC
C O2 SPAN CONC:12.00%
0 1 2 .0 0
Span Gas Concentration Setup
2
span gas of the selected
2
SO2= XX.XX
EXIT
EXIT ignores the new
ENTR EXIT
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the previous menu.