Figure 3-13: Cpu Connector Pin-Outs For Rs-232 Mode - Teledyne T100 Instruction Manual

Getting Started






52
The signals from these two connectors are routed from the motherboard via a wiring
harness to two 10-pin connectors on the CPU card, J11 and J12 (Figure 3-13).
Figure 3-13:
RS-232 COMM P
ORT
As received from the factory, the analyzer is set up to emulate a DCE or modem, with
Pin 3 of the DB-9 connector designated for receiving data and Pin 2 designated for
sending data.
RS-232: RS-232 (fixed) DB-9 male connector
Baud rate: 19200 bits per second (baud)
Data Bits: 8 data bits with 1 stop bit
Parity: None
COM2: RS-232 (configurable to RS 485), DB-9 female connector.
Baud rate:115000 bits per second (baud).
Data Bits: 8 data bits with 1 stop bit.
Parity: None.
Configuration: Section 5.1.5
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
CPU Connector Pin-Outs for RS-232 Mode
D S
EFAULT ETTINGS