Teledyne T100 Instruction Manual page 165

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
5.3.4.3. ACTIVATING HESSEN PROTOCOL
Select which COMM SETUP X.X
port to configure
ID COM1
The sum of the mode
SETUP X.X
IDs of the selected
modes is displayed
here
SET>
SETUP X.X
Repeat the
entire process to
set up the
COM2 port
The first step in configuring the T100 to operate over a Hessen protocol network is to
activate the Hessen mode for COMM ports and configure the communication
parameters for the port(s) appropriately. Access the COMM Menu (refer to Figure 5-1),
then press:
COMMUNICATIONS MENU
COM2 EXIT
COM1 MODE: 0
EDIT EXIT
COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
Continue pressing next until ...
COMM – Activating Hessen Protocol
Figure 5-29:
Remote Operation & Advanced Features
SETUP X.X COM1 HESSEN PROTOCOL: OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL: ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 E,8,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 E,8,1 MODE: ON
PREV NEXT ON ENTR
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: ON
PREV NEXT ON ENTR EXIT
Toggle OFF/ON keys
to change
activate/deactivate
selected mode.
EXIT
ENTR key accepts the
new settings
EXIT key ignores the
new settings
165