Figure 4-16: Setup - Vars Menu - Teledyne T100 Instruction Manual

Operating Instructions
To access and navigate the VARS menu, use the following button sequence.
100
SAMPLE* RANGE = 500.000 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK MORE
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
SETUP X.X ENTER VARS PASS: 818
8 1 8
SETUP X.X 0 ) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP EDIT
SETUP X.X 1 ) TPC_ENABLE=ON
PREV NEXT JUMP EDIT
SETUP X.X 2)RCELL_SET=50.0 DegC
PREV NEXT JUMP EDIT
SETUP X.X 3) IZS_SET=50.0 DegC
PREV NEXT JUMP EDIT
SETUP X.X 4 ) DYN_ZERO=ON
PREV NEXT JUMP EDIT
SETUP X.X 5) DYN_SPAN=ON
PREV NEXT JUMP EDIT
SETUP X.X 6) CONC_PRECISION : 3
PREV NEXT JUMP EDIT
SETUP X.X 7) CLOCK_ADJ=0 Sec/Day
PREV NEXT JUMP EDIT
Figure 4-16:
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
SO2 =X.XXX
SETUP
ENTR EXIT
EXIT
EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
ENTR EXIT
SETUP X.X
PRNT EXIT
1 5 .0
PRNT EXIT
SETUP X.X
ON
PRNT EXIT
PRNT EXIT
PRNT EXIT
SETUP X.X
ON
PRNT EXIT
SETUP X.X
ON
SETUP X.X
PRNT EXIT
AUTO 0
SETUP X.X
PRNT EXIT
+ 0 0
SETUP – VARS Menu
DAS_HOLD_OFF=15.0 Minutes
ENTR EXIT
Toggle this keys to change setting
TPC_ENABLE=ON
ENTR EXIT
Toggle this keys to change setting
DO NOT change
theses set-points
unless
specifically
instructed to by
T-API Customer
Service.
DYN_ZERO=ON
ENTR EXIT
Toggle this keys to change setting
DYN_SPAN=ON
ENTR EXIT
Toggle this keys to change setting
CONC_PRECUISION : 3
1 2 3 4 ENTR EXIT
Toggle these keys to change setting
CLOCK_ADJ=0 Sec/Day
ENTR EXIT
Toggle tese keys to change setting