Software Startup; Power Supply & Usb Connection - Teledyne T3SP Series Operator's Manual

multi-user systems the location of the configuration file can be changed via
the Options Dialog (see section 2.5.4).

2.3 Software Startup

The device must be turned on to operate the device, because the software
queries the device for available measurement modes. Alternatively the soft-
ware can be started with the Teledyne Viewer Key.
2.4 Power Supply & USB Connection
To enable measurements, connect the USB port of the instrument to a com-
puter. Please follow the instructions given below:
•
If available plug the Mini-USB-B plug connector of the USB-cable into
the corresponding USB-jack connector of the device and the USB-A
plug into an USB-port of your computer.
•
Turn on the device by pressing the power button for more than 1 sec-
ond. After a few seconds, the button LED changes from green to red.
The device can be turned off by pressing the power button for more
than 3 seconds.
•
The 2-state red-green LED signals have the following meaning:
Green blinking LED:
Red blinking LED:
Red permanent LED:
•
The software will automatically probe your USB ports to communicate
with the device. You can check if this was successful in the status bar
on the bottom of the main window, which shows whether the device
is Connected or Not connected.
•
If the connection to the device failed, retry to connect by pressing
T3SP-Series Operator's Manual
Device switched off, battery charging active
Device switched on, battery charging active
Device switched on, battery charging finished
9
931776 RevB