Opening Shipments From Teledyne Ml's Customer Service - Teledyne T100 Instruction Manual

3. Before using the bag or container allow any surface charges on it to dissipate:
4. Place the item in the container.
5. Seal the container. If using a bag, fold the end over and fastening it with anti-ESD
6. Once you have arrived at your destination, allow any surface charges that may have
7. Open the container.
11.5.4. OPENING SHIPMENTS FROM TELEDYNE ML'S CUSTOMER
SERVICE
Packing materials such as bubble pack and Styrofoam pellets are extremely efficient
generators of static electric charges. To prevent damage from ESD, Teledyne ML ships
all electronic components and assemblies in properly sealed anti-ESD containers.
Static charges will build up on the outer surface of the anti-ESD container during
shipping as the packing materials vibrate and rub against each other. To prevent these
static charges from damaging the components or assemblies being shipped ensure that
you always unpack shipments from Teledyne ML's Customer Service by:
1. Opening the outer shipping box away from the anti-ESD work area.
2. Carry the still sealed ant-ESD bag, tube or bin to the anti-ESD work area.
3. Follow steps 6 and 7 of Section 11.5.3 above when opening the anti-ESD container at
4. Reserve the anti-ESD container or bag to use when packing electronic components

If you are at the instrument rack, hold the bag in one hand while your wrist strap
is connected to a ground point.

If you are at an anti-ESD workbench, lay the container down on the conductive
work surface.

In either case wait several seconds.
tape.

Folding the open end over isolates the component(s) inside from the effects of
static fields.

Leaving the bag open or simply stapling it shut without folding it closed prevents
the bag from forming a complete protective envelope around the device.
built up on the bag or bin during travel to dissipate:

Connect your wrist strap to ground.

If you are at the instrument rack, hold the bag in one hand while your wrist strap
is connected to a ground point.

If you are at a anti-ESD work bench, lay the container down on the conductive
work surface

In either case wait several seconds
the work station.
or assemblies to be returned to Teledyne ML.