Table 4-5: Secondary Setup Mode Features And Functions - Teledyne T100 Instruction Manual

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
MODE OR FEATURE
External Communication
Channel Configuration
System Status Variables
System Diagnostic Features
IMPORTANT
IMPORTANT
PASSWORD LEVEL
No password Operator
818 Maintenance
929 Configuration

Table 4-5: Secondary Setup Mode Features and Functions

CONTROL
BUTTON
Used to set up and operate the analyzer's various external I/O
COMM channels including RS-232; RS 485, modem communication
and/or Ethernet access.
Used to view various variables related to the instruments current
VARS
operational status
Used to access a variety of functions that are used to configure,
test or diagnose problems with a variety of the analyzer's basic
DIAG
systems
Any changes made to a variable during one of the following procedures are not
acknowledged by the instrument until the ENTR button is pressed. If the EXIT button is
pressed before the ENTR button, the analyzer will beep, alerting the user that the newly
entered value has not been accepted.
S M P
ETUP ODE ASSWORD
When the T100's SETUP mode is activated, the instrument will prompt the user to enter
a security password. The default password is 818.
instruments basic functions and operating modes as well as some of its more powerful
diagnostic tools and variables.
The analyzer will automatically insert 818 into the password prompt field. Simply press
ENTR to proceed.
There are three levels of password protection, which correspond to operator,
maintenance and configuration functions (Table 4-6). Each level allows access to all of
the functions in the previous level.
There are more VARS available when using the password, 929, for configuration. Use
caution when pressing any buttons while in this setup. Any changes made may alter the
performance of the instrument or cause the instrument to not function properly. Note that
if there is an accidental change to a setup, press EXIT to discard the changes made.
Table 4-6: Password Levels
All functions of the MAIN menu: TEST, GEN, initiate SEQ , MSG, CLR
Access to Primary Setup and Secondary Setup Menus except for VARS and DIAG
Secondary SETUP Submenus VARS and DIAG
DESCRIPTION
S
ECURITY
MENU ACCESS ALLOWED
Operating Instructions
MANUAL
SECTION
5.1 & 5.3
This allows access to all of the
4.7
4.8
87