Teledyne T100 Instruction Manual page 139

Uv fluorescence so2 analyzer
Hide thumbs Also See for T100:
Table of Contents

Advertisement

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
A value is logged once every minute;
An average of the last 60 readings is calculated once every.
The last 480 averages are stored (20 days).
Samples are taken once per minute and reported once per minute, in effect causing the
instrument to record an instantaneous reading of each parameter every minute.
The last 360 readings for each parameter are recorded/reported.
IMPORTANT
CALDAT: Logs new slope and offset every time a zero or span calibration is
performed. This Data Channel also records the instrument reading just prior to
performing a calibration. Note: this Data Channel collects data based on an event (a
calibration) rather than a timer. This Data Channel will store data from the last 200
calibrations. This does not represent any specific length of time since it is dependent on
how often calibrations are performed. As with all Data Channels, a time and date stamp
is recorded for every data point logged.
DETAIL: Samples fourteen different parameters related to the operating status of the
analyzers optical sensors and PMT. For each parameter:
This channel is useful for diagnosing problems that cause the instruments measurements
to drift slowly over time
FAST: Almost identical to DETAIL except that for each parameter:
This channel is useful for diagnosing transients; spikes and noise problems.
These default Data Channels can be used as they are, or they can be customized to fit a
specific application. They can also be deleted to make room for custom user-
programmed Data Channels. This can be done via the instruments front panel or
downloaded via the analyzer's COM ports using a program such as APICOM (refer to
5.3.2.8) or other terminal emulation program.
Sending a DAS configuration to the analyzer through its COM ports will replace the
existing configuration and will delete all stored data. Back up any existing data and the
DAS configuration before uploading new settings
Remote Operation & Advanced Features
139

Advertisement

Table of Contents
loading

Table of Contents