Table of Contents
Advertisement
APPENDIX A - Version Specific Software Documentation
HESN:
HESSEN VARIATION: TYP2
HESSEN RESPONSE MODE: BCC
HESSEN GAS LIST:
Any gas to be reported via the serial string needs to be entered here. Enter the gas, a gas ID and whether it is
reported or not. Please note that this ID is different form the machine or internet ID stated above. For example:
SO2, 150, Reported. See table below for gas ID's needed for each analyzer. When more than one analyzer is
in a system, the second analyzer will be 2XX e.g. SO2, 250, Reported. Refer to system prints for system
specific ID's.
HESSEN STATUS FLAGS:
Set any the flag number to 0001 for any warning that should sent out on the serial string as a
common analyzer fault. All other flags should be set to 0000 except for the PPM UNITS which
should be set to 4000. Please see table below for TML recommended list of analyzer specific
flags which should be set to 0001
COM1:
COM1 MODE: *This number is a hexadecimal based on the following settings. It may change
with software revisions and therefore is not listed here.
A-42
QUITE MODE: ON
COMPUTER MODE: ON
SECURITY MODE: OFF
HESSEN PROTOCOL: ON
E,7,1 MODE: OFF
RS-485 MODE: OFF
MULTIDROP MODE: ON
ENABLE MODEM: OFF
ERROR CHECKING: OFF
XON/XOFF HANDSHAKE: OFF
HARDWARE HANDSHAKE: OFF
HARDWARE FIFO: ON
COMMAND PROMPT: OFF
COM1 BAUD RATE: 2400
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
05036 Rev D
Advertisement
Table of Contents
