Table of Contents
Advertisement
Getting Started
Table 3-13: Possible Startup Warning Messages – T100 Analyzers w/o Options
Message
ANALOG CAL WARNING
BOX TEMP WARNING
CANNOT DYN SPAN
CANNOT DYN ZERO
CONFIG INITIALIZED
DARK CAL WARNING
DATA INITIALIZED
HVPS WARNING
PMT DET WARNING
PMT TEMP WARNING
RCELL TEMP WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
SYSTEM RESET
UV LAMP WARNING
1
Clears 45 minutes after power up.
2
Clears the next time successful zero calibration is performed.
3
Clears the next time successful span calibration is performed.
68
The instrument's A/D circuitry or one of its analog outputs is not calibrated.
The temperature inside the T100 chassis is outside the specified limits.
Remote span calibration failed while the dynamic span feature was set to
2
turned on.
Remote zero calibration failed while the dynamic zero feature was set to turned
3
on.
Configuration was reset to factory defaults or was erased.
Dark offset above limit specified indicating that too much stray light is present in
the sample chamber.
DAS data storage was erased.
High voltage power supply for the PMT is outside of specified limits.
PMT detector output is outside of operational limits.
PMT temperature is outside of specified limits.
Sample chamber temperature is outside of specified limits.
CPU unable to communicate with motherboard.
CPU is unable to communicate with the relay PCA.
The flow rate of the sample gas is outside the specified limits.
Sample gas pressure outside of operational parameters.
1
The computer was rebooted.
The UV lamp intensity measured by the reference detector reading too low or
too high.
Table 3-14 lists brief descriptions of the warning messages that may occur during start
up for T100 analyzers with optional second gas options or alarms installed.
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
Meaning
Advertisement
Table of Contents
