Teledyne T100 Instruction Manual page 169

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
The <CH and
CH> keys move
the [ ] cursor left
and right along
the bit string.
5.3.4.8. INSTRUMENT ID CODE
To assign or reset the status flag bit assignments, access the COMM Menu (refer to
Figure 5-1), then press:
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1
Repeat pressing SET> until ...
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT
SETUP X. PMT DET WARNING: 0002
PREV NEXT
Repeat pressing NEXT or PREV until the desired
message flag is displayed. Refer to Table 7-15.
For Example ...
SETUP X. SYSTEM RESET: 0000
PREV NEXT
SETUP X. SYSTEM RESET: [0]000
<CH CH>
Press the [?] key repeatedly to cycle through the available character set: 0-9
Note: Values of A-F can also be set but are meaningless.
COMM – Status Flag Bit Assignment
Figure 5-32:
Each instrument on a Hessen Protocol network must have a unique ID code. The T100
is programmed with a default ID code of 100. To change this code, refer to Section
5.1.1.
Remote Operation & Advanced Features
COM2 EXIT
EXIT
EDIT PRNT EXIT
EDIT PRNT EXIT
[0] ENTR EXIT
ENTR key accepts the
new settings
EXIT key ignores the
new settings
169