Table of Contents
Advertisement
Operating Instructions
Figure 4-5: SETUP – Enter Calibration Mode Using Password
4.4. SETUP MODE
MODE OR FEATURE
Analyzer Configuration
Auto Cal Feature
Internal Data Acquisition
(DAS)
Analog Output Reporting
Range Configuration
Calibration Password Security
Internal Clock Configuration
Advanced SETUP features
86
If the calibration password (100) is enabled, the following control button sequence will
be required to enter one of the calibration modes:
SAMPLE
< TST TST >
SAMPLE
Prompts
password
number
SAMPLE
Press
individual
buttons to set
101
M-P CAL
< TST TST >
The SETUP mode contains a variety of choices that are used to configure the analyzer's
hardware and software features, perform diagnostic procedures, gather information on
the instrument's performance and configure or access data from the internal data
acquisition system (DAS). For a visual representation of the software menu trees, refer
to Appendix A-1.
The areas access under the Setup mode are divided between Primary and Secondary:
Table 4-4: Primary Setup Mode Features and Functions
CONTROL
BUTTON
CFG
Lists key hardware and software configuration information.
Used to set up and operate the AutoCal feature.
ACAL
Only appears if the analyzer has one of the internal valve
options installed.
DAS
Used to set up the DAS system and view recorded data.
Used to configure the output signals generated by the
RNGE
instrument's Analog outputs.
PASS
Turns the calibration password feature ON/OFF.
Used to Set or adjust the instrument's internal clock.
CLK
MORE
This button accesses the instruments secondary setup menu.
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
RANGE = 500.0 PPB
SO2 =XXX.X
CAL CALZ CALS
ENTER SETUP PASS : 0
0
0
0
ENTR EXIT
ENTER SETUP PASS : 0
1
0
1
ENTR EXIT
RANGE = 500.0 PPB
SO2 =XXX.X
ZERO
CONC
Continue calibration process ...
DESCRIPTION
SETUP
EXIT
MANUAL
SECTION
4.5
6.8
5.2
4.6
4.3.2
4.5.1
See
Table 4-5
Advertisement
Table of Contents
