Figure 3-26: Dilution Ratio Setup - Teledyne T100 Instruction Manual

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
3.7.1.2. DILUTION RATIO SETUP
Toggle these buttons to
set the dilution factor.
This is the number by
which the analyzer will
multiply the SO
2
concentration of the gas
passing through the
reaction cell.
Only appears if the
optional CO sensor
2
is installed.
Only appears if the
optional O sensor
2
is installed.
If the dilution ratio option is enabled on your T100 and your application involves
diluting the sample gas before it enters the analyzer, set the dilution ration as follows:
SAMPLE RANGE=500.0 PPB
<TST TST> CAL
SETUP PRIMARY SETUP MENU
CFG DAS RNGE
SETUP RANGE CONTROL MENU
UNIT DIL
SETUP CO DIL FACTOR:1.0 Gain
0 0 0
EXAMPLE
SETUP CO DIL FACTOR 20.0 Gain
0 0 0
SETUP CO2 DIL FACTOR:1.0 Gain
0 0 0
SETUP O2 DIL FACTOR:1.0 Gain
0 0 0
Figure 3-26:
SO2= XXXX
SETUP
PASS CLK MORE EXIT
EXIT
0 1 .0 ENTR EXIT
2 0 .0 ENTR EXIT
0 1 .0 ENTR EXIT
0 1 .0 ENTR EXIT
Dilution Ratio Setup
Getting Started
EXIT ignores the
new setting.
ENTR accepts the
new setting.
73