Reactivate Tool - Siemens SINUMERIK 828D Operating Manual

12.6.1

Reactivate tool

You can replace disabled tools or make them ready for use again.
Preconditions
In order to be able to reactivate a tool, the monitoring function must be activated and a
setpoint must be stored.
Procedure
Reactivating and positioning
When the "Reactivate with positioning" function is configured, the selected tool's magazine
location will also be positioned at a loading point. You can exchange the tool.
Reactivation of all monitoring types
When the "Reactivation of all monitoring types" function is configured, all the monitoring
types set in the NC for a tool are reset during reactivation.
References
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Multiple load points
If you have configured several loading points for a magazine, then the "Load Point Selection"
window appears after pressing the "Load" softkey.
Select the required load point and confirm with the "OK" softkey.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. The tool wear list is opened.
2. Position the cursor on the disabled tool which you would like to reuse.
3. Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life or
workpiece count.
The disabling of the tool is cancelled.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Tool management
12.6 Tool wear
699