10.2.3
Entering multi-channel data
In the parameter screen "Multi-channel data", enter the following data, which applies for all
channels for G code and ShopTurn programs:
● Measurement unit
● Work offset (e.g. G54)
● Z value of the work offset (optional)
● Blank
● Spindle chuck data (optional)
● Speed limitation
● Counter-spindle data, if required
● Counter-spindle with/without mirroring (for G code)
Parameter
Measurement unit
Main spindle
Work offset
Write to the
work offset
ZV
Blank
XA
XI
ZA
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Machine manufacturer
If you are working with pure G code programming, it is possible that the parameter
screen "Multi-channel data" does not open.
Please refer to the machine manufacturer's instructions.
Description
Selecting the measurement unit
Selecting the work offset
Yes
•
Parameter ZV is displayed
No
•
Parameter ZV is not displayed
Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please refer to the machine manufacturer's instructions.
Tube
•
Cylinder
•
Polygon
•
Centered cuboid
•
Outside diameter ∅ – for tube and cylinder
Inside diameter (abs) or wall thickness (inc) – only for tube
Initial dimension
Multi-channel machining
10.2 Multi-channel support
Unit
mm
inch
mm
mm
mm
619